46 8010, 8006, and 8003 chassis installation
Prerequisites
•
Procedure steps
Step
1
Copyright © 2008 Nortel Networks
.
You need the following items:
—
Standard 19-in. (48.2 cm) equipment rack
—
10 screws and washers (extra screws ship with the 8010 chassis)
—
Phillips screwdriver
Action
Hold each rack-mounting bracket against one side of the
chassis. Ensure the attachment holes in the bracket match the
holes in the chassis.
Each bracket fits only one side of the chassis. The brackets are
labeled R (right) and L (left). If the mounting holes do not line up
between a bracket and the chassis, try that bracket on the other
side of the chassis.
For more information about positioning the rack-mounting
brackets, see
Figure 10 "Positioning the rack-mounting
brackets: 8010 chassis" (page
rack-mounting brackets: 8006 chassis" (page
"Positioning the rack-mounting brackets: 8003 chassis" (page
47).
Figure 10
Positioning the rack-mounting brackets: 8010 chassis
Nortel Ethernet Routing Switch 8600
Installation — Chassis
NN46205-303 02.01 Standard
30 May 2008
46),
Figure 11 "Positioning the
47), and
Figure 12