Safety Precautions Before installation, please read the following safety precautions for user safety and to prevent product damage. Do not install the device in a place subject to direct sun light, humidity, dust or soot. Do not place a magnet near the product. Magnetic objects such as magnet, CRT, TV, monitor or speaker may damage the device.
Product Dimensions & Installation Product Dimensions 7.96 in 7.34 in (202.3 mm) (186.5 mm) 0.51 in 3.0 in 3.81 in (13 mm) 1.38 in (76.1 mm) (96.8 mm) (35mm) Mounting the Device on Wall Fix the back plate onto the wall using wall mounting screws. Note: We recommend drilling the mounting plate screws into solid wood (i.e.
Power Connection Without UPS 12V DC Adaptor With UPS (Optional) +12V 12V DC Adaptor Recommended Power Supply 12V±10%, at least 500MA. To share the power with other devices, use a power supply with higher current ratings.
Ethernet Connection LAN Connection Network Cable Adaptor Ethernet Cable Note: The device can be connected to PC directly by Ethernet cable.
Page 7
RS485 Connection RS485 Fingerprint Reader Connection RS485 Fingerprint Reader DIP Settings 1. There are six DIP switches on the back of RS485 fingerprint reader, switches 1-4 are for RS485 address, switch 5 is reserved, switch 6 is for reducing noise on long RS485 cable.
Lock Relay Connection Device Not Sharing Power with the Lock COM1 GND Sensor +12V 12V DC Adaptor FR107 Diode Normally Closed Lock Notes: 1. The system supports NO LOCK and NC LOCK. For example the NO LOCK (normally opened at power on) is connected with 'NO1' and 'COM1' terminals, and the NC LOCK (normally closed at power on) is connected with 'NC1'and 'COM1' terminals.
Page 9
Lock Relay Connection Device Sharing Power with the Lock +12V COM1 Sensor FR107 Diode Normally Closed Lock...
Device Operation Date / Time Settings Press to enter the main menu and press to select System > Date Time to set date and time. Adding User Press to enter the main menu and select User Mgt. > New User to enter the adding New User interface. Settings include inputting user ID, choosing user role (Super Admin / Normal User), registering fingerprint / badge number / password and setting access control role.
Page 13
Device Operation ADMS Settings Press to enter the main menu and press to select Comm. > ADMS, to set the parameters which are used for connecting with the ADMS server. When the Webserver is connected successfully, the initial interface will display the logo.
Page 14
Device Operation Access Control Combination Settings E.g.: Add an access control combination which requires 2 persons' verification from both group 1 (set in User Management) and group 2. 1. In “Access Control” interface, press to select “Combined Verification”; then press to enter the “Combined Verification”...