Fronius Symo Dummy; Explanation Of Footnotes; Applicable Standards And Guidelines - Fronius Symo 3.0-3-S Operating Instructions Manual

Fronius Symo
Input data
dummy
Nominal grid voltage
Grid voltage tolerance
Nominal frequency
General data
Degree of protection
Dimensions h x w x d
Weight
Explanation of 1)
footnotes
2)
3)
4)
5)
6)
Applicable stand- CE mark
ards and guide- The devices comply with all the requisite and relevant standards and guidelines that form
lines part of the relevant EU Directive, and are therefore permitted to display the CE mark.
Circuit to prevent stand alone operation
The inverter has an approved circuit to prevent stand alone operation.
Grid failure
The standard measurement and safety procedures integrated into the inverter ensure that
in the event of a grid failure, the feed-in of energy is immediately interrupted (e.g. switch-
off by the energy supplier or damage to lines).
62
The values stated are defaults; the inverter is configured specifically to suit the re-
quirements of the relevant country.
Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive)
PCC = interface to the public grid
Maximum current from the inverter to the solar module when an error occurs in the
inverter
Guaranteed by the electrical configuration of the inverter
Current peak when switching on the inverter
Dummy 3 - 10 kW
1 ~ NPE 230 V
+10 / -5 %
50 - 60 Hz
IP 65
645 x 431 x 204 mm
11 kg
Dummy 10 - 20 kW
1)
1)
IP 66
725 x 510 x 225 mm
22 kg