Inspection - HELIX CTI-CRYOGENICS CRYO-TORR 100 Installation, Operation And Servicing Instructions

)
ai-CRYOGENICS
HELIX TECHNOLOGY CORPORATION
- - - -- ------- -- - -
----~~----
Section 2:
Inspection
2.1 Packaging of the System.
2.2 The Cryopump. . . . . . .
2.1 Packaging of the System
A Cryo-Torr High-Vacuum Pump System is packaged
in three or four separate cartons, depending upon
whether an 8300 or Model SC Compressor is used.
Listed below are the contents of each carton, as they
relate to these two compressor applications. Note that
an Installation, Operation, and Servicing Manual is
included in cartons for the high-vacuum pump,
compressor and controller; each manual covers the
component packaged in that carton.
When installing a Cryo-Torr High-Vacuum Pump
System, CTI recommends that as you unpack a
component; you then perform an inspection and the
necessary tasks for system installation for the component
according to the manual (included with the component).
Final system installation and operation will be performed
following procedures in the cryopump manual
(M8040240).
2.2 The Cryopump
2-1
2-1
On receipt, remove the cryopump from its shipping
carton and inspect the cryopump for evidcnce of
damage. Report any damage to the shipper at once.
Also, retain the shipping cartons for use in storage or
return shipment.
Inspect the cryopump for damage by examining the
following:
1.
Overall exterior.
2. Mounting flange and its sealing surfaces after
removing the protective cover.
3. Louver assembly of the 80K condensing array.
Replace the protective cover.
For Your Information--
If
you are already familiar with the details of cryo-
pump installation, proceed directly to Section 3 so
your cryopump can be made operational quickly. If
not, proceed to Section 4 for detailed installation
procedures.
COMPRESSOR USED
CARTON
MANUAL
LABEL 8300
MODEL SC (AIR) NO.
CRYO-TORR@
Cryopump Cryopump
M8040240
Compressor
8300 Compressor
~
..
-
M8040241
-----
SC (Air) Compressor M8040243
Accessories Maintenance Tool Kit
Maintenance Tool Kit
and Accessories, and Accessories
..
_-
PIN 80320400013 PIN 80320400004
Controller
8001 or 8002
.~
..
-
M8040241
Controller
2-1/2-2