Changing Operation Mode; Setting Operation Mode - Honeywell ML200 Series Installation And Commissioning Manual

Chapter 3 - Plan and Install MLPLC
STOP mode
l
DEBUG mode
l
ATTENTION
Refer to ML200 CPU and SoftMaster User's Guide for further information about the module state
transition.

Changing operation mode

The following methods are used for changing the operation mode.
Using the mode key of the CPU module.
l
Using the programming tool (SoftMaster).
l
Using SoftMaster to change the operation mode of a remote CPU module networked with the
l
main CPU.
Using a networked SoftMaster, HMI and the computer link module.
l
Using the 'STOP' command, while a program is operating.
l
WARNING
Changing the operation mode can energize the field and may cause serious injury to
the users.

Setting operation mode

The operation mode for ML200-IECcan is set as follows:
Operation Mode
Switch
RUN
Stop
RUN → STOP
Remote SoftMaster
Switch Command
X X
On Run
Stop
Debug
Off Mode change
X -
Operation Mode
Run
Remote Run
Remote Stop
Debug Run
Transfer (changed) operation
mode
Stop
- 48 -