Step Action
1
2
3
4
Figure 12: Removing modules
CAUTION
While removing the module, press the hook and remove the module from the base.
Then, remove the fixed projection of the module from the module-fixing hole. If
module is detached forcefully, the hook or the fixed projection of the module may
break.
3.3
Achieving the topology
Achieving the topology for ML200-IEC
ML 200-IEC Architecture
The following figure illustrates the system configuration of ML200-IEC with 12 slot base.
From the base, loosen the fixed screws on the upper part of the module.
Hold the module and thoroughly press the fixed hook of the module.
By pressing the hook, pull the upper part of the module from the axis of the lower
part.
By lifting the module upward, remove the fixed projection of the module from the
fixing hole.
Chapter 3 - Plan and Install MLPLC
- 33 -