Siemens SIMATIC RF120C Operating Instructions Manual page 26

Parameter assignment and configuration
4.3 Parameter assignment with the device configuration
Menu: Reader type (RF600 only)
In the Reader type menu, further specific parameters are set for the reader type selected in
Reader System.
Table 4- 7 RF600 menu: Reader type
Parameter
Wireless profile
Multitag mode
Intelligent Single Tag Mode
(ISTM)
Black list
Radiated power internal
antenna (RF620R)
Transmit power (external
antenna RF620R; both
antennas RF630R)
Communication speed
Tag hold
Scanning mode
Channel assignment (only
with wireless profile ETSI)
You will find further information in the "Configuration manual RF620R_RF630R".
1)
The values for the transmit/radiated power of the antennas can be found in the following table.
2)
26
Parameter value Default value
- -
UID = EPC-ID UID = EPC-ID
(8 bytes) (8 bytes)
UID = Handle ID
(4 bytes)
On Off
Off
On Off
Off
0 - B 4
0 - 9 4
Reliable detection Reliable detection
Fast detection
On Off
Off
On Off
Off
- -
Communications module RF120C with application blocks for S7-1200 and S7-1500
Description
Selection of the relevant wireless profile for
ETSI, FCC or CMIIT.
UID = EPC-ID (8 bytes) = 8 byte UID of the
bytes 5-12 of the 12 byte long EPC-ID
UID = handle ID (4 bytes) = 4 byte UID as
handle ID for access to transponders with
EPC-ID of any length
Enable/disable the "Intelligent Single Tag
Mode ISTM" algorithm
Enable/disable the "Black list"
Setting the radiated power for the internal
antenna
1) 2)
With the RF620R, either only the internal or
only the external antenna can be set.
Setting the transmit power for the external
antenna
1) 2)
1)
Enable/disable "Tag hold"
Enable/disable the "Scanning mode"
Selection of the wireless channels to be used
1)
Operating Instructions, 07/2013, C79000-G8976-C328-01
1)
1)
1)
1)