Qualstar XLS-810160 Site Planning Manual page 24

Tape libraries
Hide thumbs Also See for XLS-810160:
Table of Contents

Advertisement

Item
4
Power cord
Door keys
Calibration cartridge
Stylus for touch screen
Data and cleaning cartridges
Barcode labels
SCSI cables
Uninterruptible power supply
(UPS) and UPS cable
Fibre Channel cables
Ethernet cables
Table 4-1 Installation check list (continued)
4-2
Provided
by
The accessory kit includes the appropriate power cord
Qualstar
for the input voltage and current.
The accessory kit includes keys to unlock the doors. The
Qualstar
same key unlocks all doors.
The accessory kit includes a calibration cartridge, which
Qualstar
is required to calibrate the tape drive locations.
The accessory kit includes a stylus, which can be used to
Qualstar
control the touch screen.
Refer to the software application and tape drive
documentation for data and cleaning cartridge
Customer
requirements. In addition to any cleaning cartridges
required for each logical library, four cleaning cartridges
are needed for the system-reserved slots.
Refer to Qualstar Product Information Note 040,
Customer
"Barcode Label Information and Specifications."
Refer to the installation plan to determine how many
SCSI cables are required. The tape drives use HD68
Customer
connectors, while the HBAs in the XLS use VHDCI
connectors.
The battery backup module provides enough backup
power to safely shut down the XLS if an unexpected
power failure occurs. However, the battery module does
not provide adequate power to protect the tape drives.
For this reason, Qualstar recommends that you connect
Customer
the XLS to an external UPS.
Note: Be sure that the UPS uses "APC Smart Signaling"
protocol and use a UPS Communication Cable
Smart Signaling (part number 940-0024)
Refer to the installation plan to determine how many
Fibre Channel cables are required. The tape drives and
Customer
the HBAs in the XLS both use multimode 62.5/125 fiber
optic patch cables with duplex LC connectors.
You must supply a CAT5e or better, straight-through
Customer
Ethernet cable to connect the library to an Ethernet
network for remote operation.
Notes
501804 Rev. 07-01-19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xls-810240

Table of Contents