Electromagnetic Compatibility - Qualstar XLS Series Site Planning Manual

Qualstar products are covered by one or more of the following patents: 6,271,982; 6,560,061; and
7,181,313. Other patents pending.
Qualstar equipment is manufactured from new parts, or new and used parts. In some cases,
Qualstar equipment may not be new and may have been previously installed. Regardless,
Qualstar's warranty terms apply unless the equipment is specifically identified by Qualstar as
"used" or "refurbished."
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense. Shielded cables are
required for this device to comply with FCC Rules. Use shielded cables when connecting this device
to others.
European Union Directive 89/336/EEC and Standard EN55022
This product has been tested and is certified to be compliant with the Class A provisions of the U.S.,
Canadian, and European standards for electromagnetic compatibility (EMC).
European Directive on Waste Electrical and Electronic Equipment (WEEE)
manufacture of all products requires the consumption of energy. By extending the life of the tape
library, energy is conserved.
In accordance with environmental directives that are being implemented in many countries (refer to
the European Directive on Waste Electrical and Electronic Equipment - WEEE), Qualstar provides
customers with
and components that make up a Qualstar tape library.
Tools required
• #1 and #2 Phillips screwdrivers
• T20 Torx head screwdriver
• Hex head (Allen) wrench/driver set
• 1/4-inch hex nut driver
Disassembly procedure
1. Remove the doors.
2. Remove the front panel.
3. Remove the external side panels.
4. Remove the internal subassemblies.
XLS Library Site Planning Guide

(Electromagnetic Compatibility)

Qualstar encourages its customers to use current recycling practices in order to reduce
the burden that waste electronic products place on the environment.
If you are retiring a fully functional tape library, you are encouraged to transfer the
functional unit to a new user, thereby extending the useful life of the tape library. The
"End of Life Instructions"
End of Life Instructions
Notices
that identify the process for recycling the materials
3