Qualstar XLS Series Site Planning Manual page 40

Item
Equipment rack (optional)
I/O port magazines
Power cord
Door keys
Calibration cartridge
Stylus for touch screen
Data and cleaning cartridges
Barcode labels
SCSI cables
Uninterruptible power supply
(UPS) and UPS cable
Fibre Channel cables
Rack-mounted equipment
Table 4-1 Installation check list (continued)
4-2
Provided
by
An 6U or 8U equipment rack can be ordered as an
Qualstar option. The 6U rack can be installed at the factory; the
8U rack must be installed in the field.
Additional I/O port magazines and covers are available
Qualstar
for long-term cartridge storage.
The accessory kit includes the appropriate power cord
Qualstar
for the input voltage and current.
The accessory kit includes keys to unlock the doors. The
Qualstar
same key unlocks all doors.
The accessory kit includes a calibration cartridge, which
Qualstar
is required to calibrate the tape drive locations.
The accessory kit includes a stylus, which can be used to
Qualstar
control the touch screen.
Refer to the software application and tape drive
documentation for data and cleaning cartridge
requirements. In addition to any cleaning cartridges
Customer
required for each logical library, four cleaning cartridges
are needed for the system-reserved slots.
Refer to Qualstar Product Information Note 040,
Customer
"Barcode Label Information and Specifications."
Refer to the installation plan to determine how many
SCSI cables are required. The tape drives use HD68
Customer
connectors, while the HBAs in the XLS use VHDCI
connectors.
The battery backup module in the power/PC bay
provides enough backup power to safely shut down the
XLS if an unexpected power failure occurs. However, the
battery module does not provide adequate power to
protect the tape drives. For this reason, Qualstar
Customer
recommends that you connect the XLS to an external
UPS.
Note: Be sure that the UPS uses "APC Smart Signaling"
protocol and use a UPS Communication Cable
Smart Signaling (part number 940-0024)
Refer to the installation plan to determine how many
Fibre Channel cables are required. The tape drives and
Customer
the HBAs in the XLS both use multimode 62.5/125 fiber
optic patch cables with duplex LC connectors.
You must provide your own equipment for the
Customer
equipment rack.
Notes
501604 Rev. 07-01-19