Programmable Inputs - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
7

Programmable inputs

EBL128 has one programmable input (I0). In EBL128 can also be
mounted the Inputs and Outputs expansion board 4583, with five
programmable inputs (Input 0-4) that can be supervised or not
supervised. See chapter "Expansion boards 458x", page 24.
On the COM loop can addressable multipurpose I/O units 3361 be
connected. Each 3361 unit has two programmable inputs (In0/Z and
In1), not supervised.
The different inputs have a bit different dialog boxes for programming
via EBLWin. Information that shall be programmed:

Name (Normally not changed, but used as Interlocking input it is
recommended to add some identification information)

Type ("Trigger condition")

Supervised or not supervised. (Not valid for 3361.)

Logic, Normally open (high resistance, 3K3, when supervised) or
Normally closed (low resistance, 680R, when supervised)

Ext. Fault (Text; only for trigger cond. "External fault")

Ext. time channel Name (only for trigger cond. "External time
channel")

Technical warnings (text).

Activate output (Technical address and Output)

Zone, Address and Text (only for trigger cond. "General fire",
"Pre-warning" and "Zone line input").

Alert Annunciation time channel (only for trigger cond. "Zone
line input" – 3361 In 0).

Disablement time channel (only for trigger cond. "Zone line
input" – 3361 In 0).
Figure 10. The EBLWin "Control unit input" dialog box. The
different trigger conditions ("Type") require different additional
information.
EBL128 Planning Instructions V2.0.x
61