Watchdog Reset; Routing Equipment Isolate (Disable); Acknowledged Alarm - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
14.3
14.4
14.5
 The battery charging is turned off 60 minutes every 24
 Battery voltage is checked during this 60 minutes period.
 Battery voltage < 24.4 V generates a fault.
Fault message:
If a fault is generated it will be Serviced after the 60 minutes period.

Watchdog reset

Normally the c.i.e. will be "dead" in case of a watchdog fault, since
the function cannot be 100% guaranteed. The fault relay output will
be "activated" since this relay is activated (powered) in normal state.
In the New Zealand convention the c.i.e. will try to restart. If it was a
small temporary disturbance that caused the watchdog fault the c.i.e.
might restart and a "restart fault" will be generated as after any restart
– else it will try to restart again and again and again.

Routing equipment isolate (disable)

If any output for routing equipment (Fire brigade tx or Fault tx) are
disabled and the door is being closed, the built-in c.i.e. buzzer will
beep for two seconds. In the LCD will be displayed: "Routing
equipment left disabled". This message has lower priority than fire
alarms but higher than other disablements and faults.

Acknowledged alarm

Acknowledged alarm has the same functionality as a normal fire alarm
except for the indication in the c.i.e. display.
When a fire alarm is activated in the c.i.e. it can be acknowledge by
pressing the "Acknowledge faults" button on the c.i.e. front.
In the fire alarm list (presented in the LCD) will "
ACK
" ".
An example:
ACK ZONE-ADDR 12-46 LAST ZONE 12
This is a user defined alarm text.
Only the alarm currently shown in the display will be acknowledged,
i.e. if there are several alarms it is necessary to scroll and
acknowledge each alarm separately.
120
EBL128 Planning Instructions V2.0.x
FAULT: Low battery capacity
th
hour.
ALM
" be changed to
No. 01