Auto Generate Loop; Ssd Download To The Control Unit - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
19.1.2
19.2
shown, i.e. an indication where the break (cut-off) or short circuit is
located.
For all units, the address (1-255) and the type of unit will be reported
to EBLWin. All differences compared to the installation (SSD) that is
open in EBLWin will be listed and can be saved and/or printed out.
"Unknown device" means that the type cannot be identified, e.g.
because it is an old type (23xx) or it is a faulty unit.
"Several reply" means that more than one unit have got the same
address or due to bad COM loop communication.
NOTE!
During this check the COM loop will be disconnected (disabled) and
no alarms or faults can be activated. Disconnected COM loop is
indicated by the LED "Disablements" (L8) on the c.i.e. front.

Auto generate loop

NOTE! If any "Obsolete units" are connected the result might be
incorrect.
The units connected to the COM loop will be identified by EBLWin
and added to the COM loop with some auto generated settings, which
can be edited before saved and downloaded as SSD to the control unit.

SSD download to the Control Unit

Start the SSD download from EBLWin, see page 153. Information in
the control unit display:
Downloading in progress......
"Progress bar......"
▓ ▓ ▓
When the download is completed the following information will be
shown:
Download completed successfully
Control unit will now restart
After the restart another text message will be shown in the display:
FAULT: Restart, code 25
Date: MM-DD Time: HH:MM
Code 25 indicates a normal restart after an ok SSD download.
Acknowledge the restart fault.
If the download was not ok another fault will be generated.
FAULT: Site specific data (SSD)
Date: MM-DD Time: HH:MM
This text message means that the SSD have not been downloaded
properly, i.e. a new download has to be performed.
152
EBL128 Planning Instructions V2.0.x
addr 0
Serviced