Mount In The Dashboard - Philips CID2780/00 User Manual

Notes on speaker connection
‡ Never connect speaker wires to the metal
body or chassis of the car.
‡ Never connect speaker wires with stripes
to one another.
Note on the power supply lead (yellow)
‡ When you connect other devices to this
system, ensure that the rating of the car
circuit is higher than the total fuse value of
all the connected devices.
Notes on rear camera connection
‡ Check your local driving regulations on
whether it is legally required to install
a rear view camera. These connections
require a professional mechanic to install.
‡ You can connect a rear view camera to
this car audio video system, so as to view
the things that happens behind your car
through the screen on the system. This
helps protecting your bumper and anything
it might contact, especially you are driving
a big vehicle.

Mount in the dashboard

Note
‡
Check wire connection before you mount the unit
into a car.
‡
If preset radio stations are lost when the ignition key is
turned off and then back on, reconnect the red leads
crosswise to the yellow ones.
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
‡ If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
‡ If the car battery is not disconnected,
to avoid a short-circuit, ensure that
bare wires do not touch each other.
2
Ensure that the car dashboard opening is
within these measurements:
‡ Since the unit cannot be used if the
dashboard opening's slant angle is
above 20 degrees: ensure that the
horizontal slant of the car dashboard
opening is between 0 and 20 degrees.
3
Slide the unit into the dashboard, until a
click sound is heard.
4
Attach the trim plate.
EN 11