Philips CID2680/93 Quick Start Manual

Philips CID2680/93 Quick Start Manual

Philips car entertainment system cid2680
Hide thumbs Also See for CID2680/93:


Quick Links

Register your product and get support at
Quick Start Guide


Table of Contents

Summary of Contents for Philips CID2680/93

  • Page 1 Register your product and get support at CID2680 Quick Start Guide...
  • Page 3 Yellow Green Blue Yellow White Black Touch controller Yellow Rear screen Amplifier...
  • Page 7: Connect Wires

    These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer. Caution • This unit is designed for negative ground (earth) 12 V DC operation only.
  • Page 8: Connect Gps Antenna

    White and Left speaker (Front) white/black wires Gray and Right speaker (Front) gray/black wires Purple and Right speaker (Rear) purple/black wires Connect the other end of the two ISO connectors to the car audio system. If necessary, do the other connections. Connect GPS antenna To receive signal from satelite, you need to connect the supplied GPS antenna to your car and the...
  • Page 9: Set Date And Time

    Touch a language to select. » The OSD language is changed to the selected language immediately. • To adjust screen brightness/contrast, press / on the remote control, then press or . • To turn off the unit, press for 3 seconds. Set date and time Touch the upper left corner to display main menu.
  • Page 10: Tune To A Radio Station

    Tune to a radio station Touch the upper left corner to display home menu. Touch [Radio]. » Band and frequency information is displayed. Touch on FM or AM to select band: • FM band options: FM1, FM2, FM3 • AM band options: AM1, AM2 Briefly touch to tune to a radio station...
  • Page 11: Adjust Sound

    Touch [Bluetooth]. » The Bluetooth menu is displayed. Touch to select the paired phone, then touch Touch to search for phone number from the following list: Or touch to dial number directly, then touch to dial. Receive call By default, all incoming calls are received automatically.
  • Page 12 100, 200. • [MPF]middle pass filter range: 500, 1K, 1.5K, 2.5K. • [HPF]high pass filter range:10K, 12.5K, 15K, 17.5K. Touch to restore the above settings into default settings. Press to exit. © 2009 Koninklijke Philips Electronics N.V. All rights reserved. CID2680_93_QSG_V1.0...

This manual is also suitable for:


Table of Contents