Contents 1 Important Safety Notice Introduction What’s in the box Overview of the main unit Overview of the remote control 2 Get started Install the car audio Install remote control battery Turn on Set date and time 3 Use map Upgrade the map 4 Listen to radio Tune to a radio station...
DivX® video (including DivX® 6) with standard playback of DivX® media ﬁles. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. Manufactured under license from Dolby Laboratories.
Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. Congratulations on your purchase, and welcome to Philips! To fully beneﬁt from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the car entertainment system, you can •...
Overview of the main unit • Eject disc. b Remote control sensor • Detects signals from the remote control. When using the remote control, point it directly at the IR sensor. c NAVI • Enter the GPS navigation system or exit.
Overview of the remote control a HOME • Toggles the home menu on or off. • Turn the unit on or off. • Adjust screen brightness/contrast. d VOLUME +/- • Adjust volume. e EQ • Access audio setting menu. • Mute or unmute audio.
w VIDEOANGLE • Select a difference angle/version of the current DVD scene. x PHOTOZOOM • Zoom in or out a picture/video image. y F/R • Switch to front/rear control mode. z Navigation buttons • Skip to the previous/next preset station. Skip to the previous/next folder.
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer. Caution • This unit is designed for negative ground (earth) 12 V DC operation only.
Orange wire Illumination switch Black wire A metal surface of the car First connect the black ground (earth) lead, then connect the yellow and red power supply leads. Yellow wire The +12V car battery which is live at all times. Blue wire The electric antenna control lead or...
Yellow Green Blue Connect GPS antenna To receive signal from satellites, connect the supplied GPS antenna to your car and the system. Connect the supplier GPS antenna to the system ﬁrst. Yellow White Black Touch controller Yellow Rear screen Amplifier...
Stick the other end of the GPS antenna to a metal surface of the car. Connect radio antenna If your car has built-in radio antenna, connect it to the radio antenna of the system for better radio signal. Connect the radio antenna to the car antenna.
Reconnect the negative terminal of the car battery. Install remote control battery Caution • Risk of explosion! Keep batteries away from heat, sunshine or ﬁre. Never discard batteries in ﬁre. Note • Remove batteries if they are exhausted or if the remote control is not to be used for a long time.
Touch [Settings]. Touch [Time]. » The date/time setup menu is displayed. Set date Touch [Date]. Touch on the displayed date information. » A submenu is displayed. Touch to set year, month and day. Set clock mode Touch [Clock mode] . Touch on [12Hr] or [24Hr] to select clock mode.
3 Use map Note • You may need to upgrade the map before using it (see “Upgrade the map” section) Touch the upper left corner to display home menu. Touch [Navigation]. » The navigation menu is displayed in a few seconds. Refer to the map manual (in Chinese) to operate the navigation tool.
4 Listen to radio Tune to a radio station Touch the upper left corner to display home menu. Touch [Radio]. » Band and frequency information is displayed. Touch on FM or AM to select band: • FM band options: FM1, FM2, FM3 •...
Touch one of the channels 01 to 06 to save the select band. Store stations automatically You can search for a station with intro search, which broadcasts a 10-second preview of each detected radio station. Select band. Touch Touch [Search]. »...
5 Play Load discs You can play video, audio or images stored on the following discs: • DVD video, DVD-R, DVD-RW • • Audio CD, CD-R, CD-RW Note • Ensure that the disc contains playable content. Insert the disc into the disc slot with label side facing up.
Insert USB or SD/MMC card Note • Ensure that the device contains playable content. • The unit supports SDHC card. Open the USB/SD/MMC card cover. Insert the SD/MMC card into the SD/MMC card slot. » Play starts automatically. Remove the SD/MMC card Press SOURCE to switch to another source.
Touch a folder, then touch select a ﬁle. Touch to start play. For picture ﬁles Touch to return to playlist menu. Touch to display all available picture folders. Touch a folder, then touch select a picture. Touch to view the picture. Search within a title/folder Search by step Touch anywhere except for the upper left...
• [Repeat folder]: play all the tracks in the current folder repeatedly. • [Repeat off]: cancel repeat play. • You can also press REPEAT on the remote control to select repeated play mode. Repeat a section You can repeat a speciﬁc section of video ﬁle (repeat A-B).
Change view angle Some DVDs contain alternate scenes, such as scenes recorded from different camera angles. For such DVDs, you can select from the available alternate scenes. During play, touch anywhere except for the upper left corner to display menu on the screen, if necessary.
6 Play with Bluetooth device You can make or receive phone calls with Bluetooth-enabled phones through the unit. You can also listen to music from a Bluetooth- enabled device. Pair the Bluetooth-enabled devices To connect your Bluetooth device to the unit, you need to pair the device to the unit.
• [Missed calls] • [Received calls] • [Dialed calls] • [Phone book] • [Sim phone book] • [Local phone book] Or touch to dial number directly, then touch to dial. Receive call By default, all incoming calls are received automatically. If there is incoming call, [Incoming call...] ﬂashes on the screen.
• [Phone Book Sync]: to synchronize phone book In Bluetooth menu, touch » The option menu is displayed. Touch on the selected option to change the setting. • You can also adjust Bluetooth settings in the “Settings” menu.
7 Adjust sound Adjust volume Turn clockwise to increase volume. • Turn anti-clockwise to reduce volume. Mute During play, press • To turn the sound back on, press again. • You can also turn off sound by touching the screen. Select preset equalizer You can select preset equalizer: •...
Touch F, R, L, or R to adjust fader/balance value. • [Fade]fader range: +24 to -24. (F = front speaker, R = rear speaker) • [Balance] balance range: -24 to +24. (L = left speaker, R = right speaker) Touch to exit.
8 Adjust settings Display system setup menu Touch the upper left corner to display main menu. Touch in the middle right side of the screen. » The second main menu is displayed. Touch [Settings]. » The settings menu is displayed. •...
[Beep] [On] Turn on the beep sound. Each time you press a button, the unit beeps. [Off] Turn off the beep sound. [Calibration] Calibrate the touch screen. Press to exit. Adjust sound settings Touch [Sound]. Touch an option repeatedly to select: Sound Options Description settings...
Video Options Description settings [Aspect [Full] For widescreen ratio] display. [Normal] For normal display. [Video [Auto] The correct format input] is set automatically. Select this option if you are not sure which format should be selected. [NTSC] Used in the United States, Canada, Japan, Mexico, the Philippines, South...
Adjust language settings Touch [Language]. Touch an option repeatedly to select: Language Options Description settings [OSD] [English] Select on-screen- display language. [DVD [English] Select DVD audio audio] language. Options available are depends on DVD disc. [DVD [English] Select DVD subtitle subtitle] language.
DVD rating Options Description [Set Set password to password] restrict the play of discs. The default password is 0000. [Rating [Kid Acceptable for level] safe] children. Acceptable for general viewers. [PG] Parental guidance suggested. [PG-13] Unsuitable for children under age 13. [PG-R] Recommend parents to restrict children under 17 to view.
9 Others Listen to other devices You can connect an external audio/video device to the unit. Connect the car audio to the device with the supplied AV cable. AV IN Touch the upper left corner to display the main menu. Touch [AV-IN1].
Check the electric connection. Buy a fuse that matches the voltage of the damaged fuse (15A) Replace the fuse. If the fuse gets damaged immediately after it has been replaced, there may be an internal malfunction. In such case, consult your Philips dealer.
10 Product information Note • Product information is subject to change without prior notice. General Power supply 12 V DC (11 V - 16 V), negative ground Fuse 15 A Suitable speaker 4 - 8 impedance Maximum power 50 W x 4 channels output Continuous power 24 W x 4 channels...
Compatible USB devices: • USB ﬂash memory (USB 2.0 or USB1.1) • USB ﬂash players (USB 2.0 or USB1.1) • memory cards (SD / MMC / SDHC) Supported formats: • USB or memory ﬁle format: FAT16, FAT32 • MP3 bit rate (data rate): 32-320 Kbps and variable bit rate •...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
• The Bluetooth function of the device is not enabled. Refer to the user manual of the device for how to enable the function. • The system is not in the pairing mode. • The system is already connected with another Bluetooth-enabled device.
12 Glossary Bite rate The max data transfer through the USB port. Bluetooth Bluetooth® is a short-rang wireless protocol that is meant to allow mobile devices to share information and applications without the worry of cables or interface incompatibilities. The name refers to a Viking King who uniﬁed Denmark.