Advertisement

The Pointe Fire Pit
Assembly and Operating Instructions for
The Pointe Fire Pit
1 |
P a g e

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pointe and is the answer not in the manual?

Questions and answers

Summary of Contents for Outdoor GreatRoom Company Pointe

  • Page 1 The Pointe Fire Pit Assembly and Operating Instructions for The Pointe Fire Pit P a g e...
  • Page 2: Table Of Contents

    Contents Contents……………………………………………………..2 Required Tools…………………………………………..3 Placing and assembling the Table.……4 Igniter Installation…………….………………………...6 Locating Propane tank……………………………8 Finishing Touches……………………………………….9 Not pictured: -Igniter module Included Items: -#21 Natural Gas orifice (x2) -#31 Liquid Propane orifice (x2) (pre-installed) -6-5lb bags of decorative fire gems -Gas hose for 20lb LP Tank –Stainless steel flex hose Base with control panel...
  • Page 3: Required Tools

    Required Tools 2 Open Ended Wrenches  To make gas connections Leather Gloves  To protect hands from rough edges found on the coffee table. One (1) AAA Battery (not  included) Required for piezoelectric igniter installation. AT LEAST two people required ...
  • Page 4: Placing And Assembling The Table

    Placing and Assembling the Fire Pit table 1. After removing the fire pit from packaging, move the base without door to desired location and set into place. 2. When locating your coffee table, refer to the Crystal Fire manual and maintain clearance to combustibles. 3.
  • Page 5 *base shown may differ from actual product Attach incoming gas here Stainless flex line to burner 6. Connect incoming gas line (black rubber propane hose or hard pipe from outside source) to the lower fitting on the control valve, ensuring the knob is in the “OFF” position. Carefully set burner back into place in the table top.
  • Page 6: Igniter Installation

    Igniter Installation 1. Make sure the valve is in the OFF position 2. Unscrew sparker cap and hex nut. Install as shown below. P a g e...
  • Page 7 3. To properly install ignition system, a spark and ground wire need to be attached to the igniter box.  Start by plugging the black wire hanging from the burner in to one side of the back of the igniter. ...
  • Page 8: Locating Propane Tank

    Locating your Tank 1. Your tank should be positioned so that the fuel can be shut off after each use. 2. Slide the tank into the framework past the line shown below. This is to allow the door to close completely. 3.
  • Page 9: Finishing Touches

    Finishing touches Once fire pit is set up and in the desired position, scatter decorative glass on burner surface forming an even layer of beads.  DO NOT BURN WITHOUT GLASS OR OTHER DECORATIVE SUBSTRATE PRESENT IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to hooking up your linear burner, including safety information, proper tightening of connections with two wrenches and full burner setup and lighting...
  • Page 10 Warranty: Fire pit tables are covered under a 1- year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form to register your product. © 2014 The Outdoor GreatRoom Company 14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.com...

Table of Contents