Contents Contents………………………………………………………………………………..2 Required Tools……………………………………………………………..……..2 Assembling the Grand Colonial…………………………….………4 Assembling the Colonial…………………………………..………………6 Gas Connections…………….…………………………………………..……...7 Installing Igniter……………………………………………………………………8 Placing propane tank and finishing touches……………..12 Required Tools Utility Knife To cut and remove packaging 2 Open Ended Wrenches To make gas connections ...
Page 3
Depending on which model you purchased, turn to the corresponding page in this manual for installation instructions. Included with Grand Colonial (Instructions begin on next page) Lazy Susan/Burner Cover Tabletop frame Base Granite Pieces (x4) Screws (x4) Top-Securing Bracket (x4)
Page 4
Assembling the Grand Colonial 1. Remove all components from packaging and inspect for damage or missing parts. 2. Move the base to desired location and set into place before installing granite. - When locating your coffee table, refer to the Crystal Fire manual and maintain clearance to combustibles.
Page 5
4. With top centered on base and one hole approximately centered on each corner of the base, insert a mounting clip into mounting hole (refer to image at right.) 5. Insert one of the included screws through the hole in the mounting clip and screw into the table base.
Page 6
Colonial Table Setup Remove all components from packaging and inspect for damage or missing parts. Place the fiberglass table base in your desired location on flat, level ground. Viewing the base from above, place a riser piece on each corner of the base as shown below...
Read and understand your Crystal Fire burner owner’s manual before beginning burner hookups or using the device. Gas Connection 1. With proper orifice installed for the application (#43 for propane, #31 for natural gas) and metal flex hose attached, set burner in base. 2.
Igniter Installation Your Crystal Fire ™ burner includes one of two styles of igniter. These can be distinguished by the number of wire connection prongs on the back (glossy) side. If one prong is present see below, otherwise turn to page 10 for instructions on how to install and use a two-pronged igniter.
Page 9
Step 4: Slide the igniter with attached grounding wire through the hole in the fiberglass base from the inside and tighten the plastic nut onto the shaft until snug but not overtightened. Before screwing button cap on, insert one AAA battery into igniter, + side facing out.
Page 10
If your Crystal Fire burner included a double-pronged igniter, there will be a grounding wire attached to the bottom of your burner bowl and the included grounding wire with your Colonial will not be used. 1. Make sure the valve is in the OFF position 2.
Page 11
3. To properly install ignition system, a spark and ground wire need to be attached to the igniter box. Start by plugging the black wire hanging from the burner in to one side of the back of the igniter. ...
Page 12
Locating your Tank 1. Your tank should be positioned so that the fuel can be shut off after each use. 2. Set tank inside base with adequate clearance to burner so the two are not touching. 3. Confirm all hoses are clear and not touching the burner.
Page 13
IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to hooking up your linear burner, including safety information, proper tightening of connections with two wrenches and full burner setup and lighting instructions. DO NOT ATTEMPT TO INSTALL CF-20 BURNER WITHOUT FIRST CONSULTING THE MANUAL.
Page 14
Warranty: Fire pit tables are covered under a 1- year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form to register your product. 14 | P a g e...
Need help?
Do you have a question about the Colonial and is the answer not in the manual?
Questions and answers