Advertisement
Quick Links
Advertisement
Related Manuals for Outdoor GreatRoom Company Tuscany Fire Table
Summary of Contents for Outdoor GreatRoom Company Tuscany Fire Table
- Page 1 Tuscany Fire Table—Manual and Installation Instructions Revised 8/4/2010...
- Page 2 Introduction: Thank you for your purchase from The Outdoor GreatRoom Company. We are sure you’ll enjoy many evenings gathered around the fire. The Tuscany Fire Table surround is manufactured to be used with the Crystal Fire Pit Burner Assembly. This item is not included with the Tuscany Table packaging.
- Page 3 Parts List Tuscany Fire Table Base Tuscany Fire Table Top Tuscany Fire Table Door Tuscany Fire Table Control Panel...
- Page 4 Step 1: Set the base in place Step 2: Install the control panel NOTE: There are no screws necessary for the installation of the control panel. This is a fric- tion fit control panel. It may be necessary to slightly bend out the inner tab to fit around the base.
- Page 5 Step 4: Connect the gas supply flex line NOTE: To ensure proper connections contact your local gas authority. Step 5: Connect the propane hose with regulator. NOTE: To ensure proper connections contact your local gas authority. Step 6: Install the push button sparker from the Crystal Fire.
- Page 6 NOTE: Remove the plastic nut, to expose the brass grounding contact point. Then replace the nut, install a AAA battery, and cap. Step 7: Install the cap and hand tighten. Step 8: Install the top so that it is centered on the base.
- Page 7 Step 9: Install the Crystal Fire. Step 10: Connect the gas supply flex line to the Crystal Fire. NOTE: To ensure proper connections contact your local gas authority. Step 11: Connect the ignition wire to the back of the sparker module.
- Page 8 Step 12: Connect the propane hose the to prone tank. NOTE: Propane tank not included. NOTE: To ensure proper connections contact your local gas authority. Step 13: Put the door in place to conceal the propane tank Step 14: Place the tumbled glass on top of the Crystal Fire.
- Page 9 Igniting the Crystal Fire: Make sure the con- trol panel valve is turned to OFF. After this is confirmed, turn on the propane tank. Depress the push button ignition and slowly turn the control panel valve to ON to ignite the unit.
Need help?
Do you have a question about the Tuscany Fire Table and is the answer not in the manual?
Questions and answers