BT Vision Customer Self Install Manual page 20

FAQs
First Adapter (Note: Status Light may be red or
green at this point).
• Once the orange AP Light stops flashing (should
now be solid orange) press the [CONFIG/F RESET]
button on the same Powerline Adapter until the
AP Light starts flashing again. Then release the
[CONFIG/F RESET] button.
• Next press the [CONFIG/F RESET] button on
the other Powerline Adapter (Second Adapter)
until the AP Light starts flashing (make sure this
is done immediately after the First Powerline
Adapter) then release the [CONFIG/F RESET]
button.
Second Adapter (Note: Status Light may be red
or green at this point).
• After a few seconds, the Status Lights should go
green on both adapters and the AP Light on the
first Adapter should be orange.
• Both devices can now be repositioned in their
original location.
• For further
Powerline Adapters please visit
www.btvision.com/help
34
FAQs
Help and Support on your
FAQs
Can I use extension strips with my Powerline
Adapters?
Perfect
ON/SBY
Config/
F. Reset
STATUS
Ethernet
AP
Perfect if plugging in other
devices
ON/SBY
Config/
F. Reset
STATUS
Ethernet
AP
Perfect if plugging in other
devices
ON/SBY
Config/
F. Reset
STATUS
Ethernet
AP
Self Install Guide FAQs
ANTI SURGE PROTECTOR
35