BT Vision Powerline Adapters
What's in the box
Powerline adapters x2, ethernet cable, Quick Start guide
Connecting your Powerlines
If your BT Home Hub is in another room or is more than two
metres away from your Vision+ box you'll need to use your
Powerline adapters
1 Using the Ethernet cable (yellow ends), connect one end to
your Hub's Ethernet port 1
2 Connect the other end to a Powerline adapter
3 Then plug the Powerline adapter directly into a power
socket and turn it on
4 Using the Ethernet cable provided with your Vision+ box,
connect one end to the LAN socket at the back of your
Vision+ box
5 Connect the other end to a Powerline adapter
6 Then plug the Powerline adapter directly into a power
socket and turn it on. When you've plugged in both your
Powerline adapters, their Data lights should glow green
Note: your Powerline adapters will work with any version
of the BT Home Hub and Vision+ box, not just the ones
shown in the diagram
IMPORTANT: to work properly Powerline
adapters must be plugged directly into the
wall socket and not into extension leads
LED status description
Green
Powerline network is detected with high transfer speed
Powerline network is detected with medium transfer speed
Orange
Powerline network is detected with low transfer speed
Red
Flashing
Any of the above flashing – a data transfer in progress
No Powerline connection
Off
Ethernet connection is detected
Green steady
Ethernet traffic is detected
Green flashing
Power is on
Green steady
Green flashing
The unit is in pairing mode, see overleaf
The mains power is off or the unit is in sleep mode.
Off
The unit automatically wakes up from sleep mode when the
device connected to the Ethernet cable is powered up.
1
5
4
2
Data
Ethernet
Power
3
6