Siemens SITOP PSU8200 Manual page 60

7 Power supply system SITOP PSU8600
Setting the SITOP PSU8600 parameters (commissioning)
In the HW configuration for the PSU8600, you can set general parameters,
parameters for R F energy and the output parameters of the basic module's and
the expansion module's 24 V outputs.
You can find more detailed information on the different parameters in the "SITOP
PSU8600" manual at the following link:
https://support.industry.siemens.com/cs/ww/en/view/105867947
Proceed as follows:
1. Select the PSU8600 (1) in the hardware configuration.
2. Open the properties of the "PSU8600 3ph" module (2) on slot 0.1 by double-
clicking.
3. Switch to the "Parameters" tab and set the parameters (3) as desired.
4. Open the properties of the 24 V outputs one after the other (4) and set the
parameters of the outputs as desired.
5. For the 24 V outputs of the CNX8600 module, proceed as described in section
4.
6. Open the properties of the "UPS8600" module at slot 3.1 and set the
parameters as required.
7. Compile and load the hardware configuration.
Integration of a SITOP 24V power supply in PCS 7
Entry ID: 10948108, V3.2, 01/2019
60