Siemens SIMATIC Box PC 620 Manual page 79

Note
The slide elements are in the enclosed plastic bag.
Aligning the Holding-Down Device
Proceed as follows to install the holding-down device.
1. Insert the slide element through the guide slit until it is resting firmly on the
module. The module must now be introduced into the notch.
Caution
!
No pressure may be exerted on the module! Therefore, do not use force to press
the slide element onto the module.
2. Cut off the projecting part of the slide element:
– Score the slide element at the top edge of the holding-down device with a
knife and break it off.
– Nip off the surplus with a sharp side cutter.
SIMATIC Box PC 620 Manual
A5E00131465-03
www.aotewell.com
SIMATIC Box PC 620 Expansions
sales@aotewell.com
Industry Automation
4-15
+86-755-8660-6182