An Error Message Appears On The Screen - Siemens SIMATIC Box PC 620 Manual

Error Diagnosis
6.7

An Error Message Appears on the Screen

Error Messages
The following table describes the error messages that the BIOS system outputs.
Error messages the operating system or program outputs are described in the
manuals for these programs.
Press <F2> to call Setup when booting the computer.
Error Message on the Screen
System battery is dead
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Incorrect Drive A type
Run SETUP
Incorrect Drive B type
Run SETUP
Diskette drive A error
Diskette drive B error
Failure Fixed Disk
Keyboard error
Stuck Key
System RAM Failed at offset:
Shadow RAM Failed at offset:
Extended RAM Failed at offset: Memory error
Operating system not found
Previous boot incomplete
Default configuration used
System cache error
Cache disabled
Monitor type does not match
CMOS
Run SETUP
System timer error
6-6
www.aotewell.com
Meaning/Suggestion
The battery on the CPU module is defective or dead.
Contact your technical support team
Call up SETUP, adjust settings and save. If this message appears
during each power up, contact your technical support team.
Check the SETUP entries for drive A.
Check the SETUP entries for drive B.
Error accessing drive A.
Contact your technical support team.
Error accessing drive B.
Contact your technical support team.
Error accessing the hard drive.
Check the SETUP settings
Contact your technical support team.
Check whether the keyboard is connected correctly.
Check whether a key on the keyboard is stuck.
Memory error
Contact your technical support team.
Memory error
Contact your technical support team
Contact your technical support team
Possible causes:
No operating system present
Incorrect drive addressed (diskette in drive A/B)
Incorrect active boot partition
Incorrect entries in SETUP for the BOOT drive
Abort of the previous BOOT procedure, for example, due to a power
failure. Restart ist performed with the default configuration data. If
necessary check the hardware settings and the SETUP.
Error in the CPU's cache module.
Contact your technical support team.
The monitor does not match the SETUP entries.
Adapt the SETUP entries to the monitor.
Hardware error
Contact your technical support team.
sales@aotewell.com
Industry Automation
SIMATIC Box PC 620 Manual
A5E00131465-03
+86-755-8660-6182