Pro-face PS-A Series Installation Manual page 17

USB Cable Holder Installation
This holder prevents the USB cable from becoming disconnected due to vibration,
etc. Place the PS-A unit face-down on a flat surface as shown below. Your PS-A
unit has two USB connectors.
• When using both USB connectors, be sure to first connect one USB cable to
the lower USB connector, then connect the second USB cable to the upper
USB connector.
• When using only one of the USB ports, be sure to use the lower USB connec-
tor. This allows you to securely clamp the USB cable in the cable clamp.
[Attachment]
As shown below, insert the USB Cable Clamp's band through the Bridge. Pass the
USB cables through the Cable Clamp's band and securely tighten the clamp band
around the cables.
• Be sure the clamp is securely holding the USB cable's plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing
upwards – not to the side. This is to keep the clamp from interfering with
nearby connectors and their cables.
[Removal]
To remove the clamp from the USB cables, push down on the clamp strap's clip to
release it while pulling up on the clamp.
Band
Cable Collars
Bridge
USB Cable
Clamp
Upper USB Interface
Lower USB Interface
Clamp
Clip
E-17