Table of Contents
Advertisement
188
4-3. Operating the lights and wipers
Automatic High Beam
*
: If equipped
The Automatic High Beam
uses a camera sensor located
behind the upper portion of the
windshield to assess the
brightness of the lights of vehi-
cles ahead, streetlights, etc.,
and automatically turns the
high beams on or off as neces-
sary.
WARNING
■
Limitations of the Automatic
High Beam
Do not overly rely on the Automatic
High Beam. Always drive safely, tak-
ing care to observe your surroundings
and turning the high beams on or off
manually if necessary.
■
To prevent incorrect operation of
the Automatic High Beam system
Do not overload the vehicle.
Activating the Automatic
High Beam
1
Press the Automatic High Beam
switch.
COROLLA HV_ 国瑞 _GE
COROLLA HYBRID_OM_General_OM12M44E
2
Push the lever away from you
*
with the headlight switch in the
or
The Automatic High Beam indicator will
come on when the system is operating.
■
Conditions to turn the high beams
on/off automatically
When all of the following conditions
●
are met, the high beams will be turned
on automatically (after approximately
1 second):
• The vehicle speed is approximately 30
km/h (19 mph) or more.
• The area ahead of the vehicle is dark.
• There are no vehicles ahead with
headlights or tail lights turned on.
• There are few streetlights on the road
ahead.
●
If any of the following conditions are
met, the high beams will turn off auto-
matically:
• The vehicle speed is below approxi-
mately 25 km/h (16 mph).
• The area ahead of the vehicle is not
dark.
• Vehicles ahead have their headlights
or tail lights turned on.
• There are many streetlights on the
road ahead.
■
Camera sensor detection informa-
tion
The high beams may not be automati-
●
cally turned off in the following situa-
tions:
• When a vehicle suddenly appears
from around a curve
position.
Advertisement
Table of Contents
