Unicum FOODBOX LIFT TOUCH User Manual page 21

ТМ
FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH
7. The connector is not used
8. Modem power and MDB payment system connector
9. Controller board power connector (~24V)
10. The connector is not used
11. Power board connector (CAN-BUS)
12. Vending machine PC unit connector (Ethernet)
13. The connector is not used
14. The connector is not used
The vending machine controller permits conducting the vending machine setting, software updating
and collecting the statistics by means of file interchange via the USB-flash drive.
The drive is connected to the USB connector, located on the controller board (fig. 12). The connection
should be carried out in the sales mode. When connecting the drive the touch screen will display the
relevant messages about the drive operation.
ATTENTIoN! The vending machine accepts USb-flash drives only! Disk drive and flash-disks
are not supported. only USb-flash drives with fAT16 or fAT32 file systems are supported. other
file systems (including NTfS) are not supported.
Information that may be read from the USb-flash drive from the vending machine:
1. Statistics (Audit): The information about the vending machine operation, sales, equipment oper-
ation, events. is saved to files in the EVA-DTS format, file name: Axxmmddi.DTS
- хх = the 2 last digits of the vending machine serial number;
- mm = month (if date and time are set in the vending machine menu);
- dd = date (if date and time are set in the vending machine menu);
- i = a number in the range from 0 to 9. You can save up to 10 files with different names within 24
hours.
To read the information insert the USB-flash drive into the controller board connector while in sales
mode and confirm the Save audit? request.
2. Current configuration: File in the EVA-DTS format. Filename: сххххххх.DTS, then the 7-digit
vending machine number, (e.g.: с0000123.DTS).
The file contains the information about the equipment configuration, as well as the information about
the products placement, names, and prices.
To read the information insert the USB-flash drive into the controller board connector while in sales
mode and confirm the Record configuration? request.
Information that may be loaded from the USb-flash drive into the vending machine:
1. Configuration for the specific vending machine: File in the EVA-DTS format. File mane:
сххххххх.DTS, then the 7-digit vending machine number. The file will be loaded into the vending machine
only if it matches the number and in the file name. This permits loading different configurations for different
vending machines from one USB-flash drive.
To load the information insert the USB-flash drive into the controller board connector while in sales
mode and confirm the Load configuration? request.
2. General configuration: File in the EVA-DTS format. Filename: CONF_GEN.DTS. The file can be
loaded into the vending machine with any number.
To load the information insert the USB-flash drive into the controller board connector while in sales
mode and confirm the Load the main configuration? request.
Version 1.3 / December 2018 Page 21