Unicum FOODBOX LIFT TOUCH User Manual page 43

ТМ
FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH
SETTING
Min box temperature (sensor 1), °С
Max box temperature (sensor 1), °С
Min evaporator temperature (sensor 3),
°С
Max evaporator temperature (sensor
3), °С
Evaporator fan options
Version 1.3 / December 2018
DESCRIPTIoN
This setting is effective only if the bY EVAPoRAToR AND
box TEMPERATURE mode is selected.
The setting of the minimum temperature at the bottom of
the product storage bay.
When this temperature is reached the vending machine
stops cooling.
After changing this field one should correct the minimum
value at the sensor 1 temperature control in the SNACK
1/2 tab, if this control is adjusted (the value in the control
should be min. 2 degrees lower than a value in this field).
This setting is effective only if the bY EVAPoRAToR AND
box TEMPERATURE mode is selected.
The setting of the maximum temperature at the bottom of
the product storage bay.
When this temperature is reached the vending machine
starts cooling.
After changing this field one should correct the maximum
value at the sensor 1 temperature control in the SNACK
1/2 tab, if this control is adjusted (the value in the control
should be min. 2 degrees higher than a value in this field).
This setting operates differently in different modes. If the
bY EVAPoRAToR TEMPERATURE mode is selected,
then this setting specifies the evaporator temperature,
by reaching which the vending machine stops cooling.
If the bY EVAPoRAToR AND box TEMPERATURE
mode is selected, then here the temperature is specified
by reaching which the vending machine considers that the
evaporator is frosted and activates the anti-frosting cycle
(in this mode the temperature is specified that is usually
a little bit higher than the gas boiling temperature, i.e. the
temperature of minus 6 degrees is specified).
After changing this field one should correct the minimum
value at the sensor 3 temperature control in the SNACK
1/2 tab, if this control is adjusted (the value in the control
should be min. 2 degrees lower than a value in this field).
This setting operates differently in different modes. If the
bY EVAPoRAToR TEMPERATURE mode is selected,
then this setting specifies the evaporator temperature, by
reaching which the vending machine starts cooling.
If the bY EVAPoRAToR AND box TEMPERATURE
mode is selected, then here the temperature is specified
by reaching which during the anti-frosting cycle the vend-
ing machine stops the cycle earlier (in this mode the tem-
perature is specified at which all the ice on the evaporator
is positively melted; the recommended temperature is +10
degrees).
After changing this field one should correct the maximum
value at the sensor 3 temperature control in the SNACK
1/2 tab, if this control is adjusted (the value in the control
should be min. 2 degrees higher than a value in this field).
The selection of the cooling unit fan operating mode:
ALWAYS oN - the fan is always on;
oN WITH CoMPRESSoR oNLY - operated in the cooling
mode only;
oN WITH CoMPRESSoR AND DURING DEfRoST - op-
erated when cooling and defrosting.
VALUE
Input value
Input value
Input value
Input value
Always ON
ON with
compressor only
ON with
compressor and during
defrost
Page 43