Electrical Connection; Wall Mounting - Unicum FOODBOX LIFT TOUCH User Manual

ТМ
FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH
ATTENTIoN!
To prevent the vending machine from overturning it's prohibited to open the vending
machine doors and pulling out the shelves until the vending machine is securely fixed
on the mounting surface!

5.4 Electrical connection

The vending machine is supplied ready for connection by using a power cord to a ~230 V / 50 Hz
single-phase AC power circuit. The vending machine should be connected to the wall outlet with grounding
contact.
After the electrical connection, the vending machine plug should be accessible.

5.5 Wall mounting

The vending machine design permits its mounting to the wall. The wall mounting helps preventing
the vending machine from overturning in the cases of damaging and breaking.
To mount the vending machine to the wall:
- take the rests and self-tapping screw packed for the duration of transportation into the product
dispensing tray;
- fix the rests to the vending machine by using four screws;
- move the vending machine close to the wall;
- mark the location of mounting holes by a marker;
- move the vending machine away from the wall and drill 2 blind holes for the screw plugs installation;
- install the screw plugs and move the vending machine to the wall, so that the fixing holes in the wall
match with the holes in the rests. Then fix the vending machine by using self-tapping screws.
Note: When fixing the vending machine to the wall, at the first place fix the wall mount rests to the
vending machine, and only then proceed fixing the vending machine to the wall!
Version 1.3 / December 2018
1 - Self-tapping screw
2 - Screw plug
figure 7 - Vending machine wall mounting
Page 15