Fixture Settings; Fixture Information - ProLights STUDIOCOB TU-DY User Manual

3.13 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows Dimmer Mode, and press the button ENTER to confirm.
• Press the button UP/DOWN to select Off - Dimmer 1 - Dimmer 2 - Dimmer 3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
BackLite
• To activate Backlight display press the button MENU so many times until shows Back Light, and press
the button ENTER to confirm.
• Press the button UP/DOWN to select On - 10S - 20S - 30S.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
LED Frequency
• To adjust the frequency of the LEDs, press the MENU button repeatedly until the display shows LED
Frequency, and then press the ENTER button.
• Select the frequency (600 Hz - 1200 Hz - 2000 Hz - 4000 Hz - 25 kHz) using the UP/DOWN buttons.
• To confirm, press the ENTER key.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
Fan Mode
• To set the rotation speed of the fans refer to the following guide:
• Press the MENU key repeatedly until the display shows Fan Mode, then press the button ENTER.
• Select by pressing UP/DOWN one of the following options: Auto - High. It is possible choose the
speed of rotation of the fans from: fast High and automatic Auto.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.

3.14 FIXTURE INFORMATION

Fixture Hours
Show the fixture working hours.
• Press the button MENU so many times until shows Information. Press the button ENTER to confirm
• Using the button UP/DOWN to select Fixture Hours, then press the button ENTER to confirm
• Then the display will show the working hours.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically
Version
Show the fixture firmware version.
• Press the button MENU so many times until shows Information
• Select through the button UP/DOWN the Version menu voice.
• The display will show the firmware data.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automatically.
STUDIOCOB TU-DY
13