Advertisement
Available languages
Available languages
Safety instructions / warnings
The owner and / or user must have read and understood the operating instructions of the device be-
fore using it. Installed personnel should be cautious, competent, trained and qualified in the safe han-
dling of the working equipment used when working with the shop press. Warnings should be read and
understood.
1. Be familiar with the application control, the application process and the warnings.
2. Ensure that all connectors are secure and secure.
3. Make sure you know the contents of the instructions for use.
4. This device is not intended to be used by persons (or even children) with reduced physical,
sensory or mental abilities or persons who do not have the appropriate experience or
knowledge, unless they are responsible for their safety Person or have previously been in-
structed to use the equipment.
5. Children must be supervised to ensure that they do not play with the appliance.
6. Stay concentrated and do not allow any distraction during the process.
7. Do not use welding equipment near the support.
8. Always pay attention to the optimal lighting of the workplace.
9. Be sure to wear solid footwear.
10. Use a hairnet for long hair
11. Wear tight clothing.
12. Place jewelry (rings, earrings, watches, etc.)
13. Be careful not to wear loose straps or belts.
14. Long working in a standing position can lead to dizziness. Make regular breaks and drink
enough.
15. Never open the screw connections under pressure / load.
16. Set the press to the lowest position when refilling hydraulic oil. Use only high quality hydraulic
oil, NEVER brake fluid, alcohol, glycerine, detergent, engine oil, water, contaminated oil or
other inappropriate fluids.
17. The hydraulic cylinder is under pressure and must not be opened by force.
Inspection / inspection
Prior to commissioning the shop press, visual inspection must be carried out to detect leaks, damage,
loose or missing parts and worn parts.
Check the oil level regularly. Set the press to the lowest position when refilling hydraulic oil. Remove
the cap, the oil level must reach exactly to the opening. If necessary, refill with high-quality hydraulic
oil. Perform a complete oil change every year.
If scrapping of the press lever is necessary, the oil should be drained and disposed of properly, the
rest of the press should be recycled.
Operation
1. Place work piece on bed frame
2. Locate and close release valve by turning it clockwise until tight
3. Pump handle until the ram nears work piece
4. Align ram and work piece to ensure centre loading
5. Apply load to work piece by pumping handle. Do not overload work piece
6. Remove load from work piece by turning release valve counterclockwise. Stabilize work piece so it
does not fall while pressure is released.
7. Remove work piece until ram is fully retracted.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 12
Advertisement
