The Actual Punch-Ln; Remote Punch-In/Out Using The Rc-30P Pedal - Teac TASCAM 388 STUDIO 8 Operation & Maintenance Manual

THE ACTUAL PUNCH-IN
1.The INSERT switch should be ¡n the on
position (down). Its LED will be on. The MON
switch (PGM/CUE) remains in the CUE posi
tion.
2. Press the appropriate REO FUNCTION
switch.
3. Make sure all other REO FUNCTION
switches are off (up).
4. Press PLAY.
5. Just before you reach the edit point, press
REC.
6. Perform the new material. When you reach
the point that you'd like to end the edit, punch-
out, press STOP, PLAY, or REW turning off the
record mode.
actual
PUNCH-IN
ííy <^r
I coca annoPao
N H H
1 6 4 5
REMOTE PUNCH-IN/OUT USING THE RC-
30P PEDAL
Rehearse in the same way as your did before.
When you're ready to go.. .
1) Start the recordar rolling by pressing
PLAY. The REC FUNCTION switch should be
on, with its LED blinking.
2) When the Punch-in point arrives, step on
the RC-30P pedal. This will start the Recordinq
process.
3) When the Punch out point arrives step on
the RC-30P pedal again. This will stop the
Recording process.
t.
14 -