Teac TASCAM 388 STUDIO 8 Operation & Maintenance Manual page 10

3. Press down REC FUNCTION 2. Its LED
will blink. Make sure all other REC FUNC
TION switches are off (up) with their LEDs
off.
4. Raise the EVEN PGM MASTERS Fader
to the shaded area between 7 and 8.
5. Press PLAY and listen to your first track
through headphones. Make any necessary ad-
justments to MONITOR 1 GAIN and PAN con-
trols. Adjust the MONITOR/PHONES level for
comfort.
6. Adjust MONITOR GAIN 2 so that your
instrument or volee and track 1 are at the
proper balance in the headphones.
7. Play your instrument or speak into the
microphone. If you counted on track 1, you
will aiso count on track 2. The objective is to
use oniy the even numbers to twenty, placing
them in the pauses between the odd numbers
used on track 1.
8. Adjust the channel Fader 1, while watching
TRK/PGM Meter 2. It should read cióse to 0.
9. Rewind the tape by pressing the RTZ
button. It should stop at 00:00.
10. Press REC and PLAY at the same time.
REC FUNCTION 2 LED will stop blinking
and stay on continuousiy.
11. Play your instrument or count the even
numbers to twenty. When finished, press STOP
and RTZ.
12. Press ASSIGN 1-2, turning it off (up).
13. Press REC FUNCTION 2 switch, turning
ti off (up). Its LED will go off.
14. You can now listen to both tracks. Press
MONO, releasing the mono mode. Adjust MONI
TOR PAN for 1 and 2 to the desired locatjon
Adjust MONITRO GAIN for 1 and 2 to the
desired level.
Tracks 3 through 8 can be recorded using
similar procedures as track 1 and 2. The differ-
ences, of course, are that the PGM ASSIGN
switches and REC FUNCTION switches will
correspond to the desired recorder tracks. PAN
controls in any channeis of the mixer will be
rotated to match the ODD (3,5, and 7) or EVEN
(4, 6, and 8) tracks. Readjust MONITOR GAIN
and PAN as desired.
4^.
OVERDUBBING
6 4,14
9, 11
4 14 11 5 10
- 10 -