Reel Motor; Capstan Motor - Teac TASCAM 388 STUDIO 8 Operation & Maintenance Manual

1-2-2. Reel Motor
1.After removing the top panel and bottom
píate, remove the reel table assembly as shown
in Fig. 1-2-2, and remove thefour screws hold
ing the reel motor.
2. Finally, undo the wire running to the MECHA
JOINT PCB with the use of a soldering iron.
1-2-3. Capstan Motor
1. Remove the Motor Pulley from the Capstan
Motor.
2. Remove the four screws @ from th® otor
Bracket.
3. Remove the four screws (b) holding the Reel
Motor.
4. Unsolder the wire from the MECHA JOINT
PCB.
Reel Table
Reel Motor
Screw(b)
Capstan Motor
Motor Bracket
Screw (i)
Motor Pulley
Set Screw
Fig. 1-2-2. Reel Motor Removing
Fig. 1-2-3. Capstan Motor Removing
/
1 5