Table of Contents
Advertisement
Saving the Configuration
Enter the
Remote IP Address
on the LAN (LAN user was entered in field
is the logical port for the protocol (UDP or TCP) you select for this NAT entry
Port
Your system administrator will provide the protocol port number.
If you do not have the information for the remote user and port, enter 0.0.0.0 for the
Remote IP Address
Ž
Select a
Protocol
remote user for this static NAT entry. (See
about the transport protocols.)
This field lists the
fields defined. You can have up to 32 static entries.
2
Click
Add
to accept the
3
Repeat
Step 1
4
To delete a
Static NAT Entry
5
Click
to return to the
Done
S
AVING THE
Although you have submitted new settings, the parameters are not permanent until you write
them to NVRAM. See
configurations to NVRAM.
42
for a user at a remote site that you are mapping to a user
and/or 0 for the
(UDP or TCP) for the transport used between the LAN and the
IP Address
,
Port,
Static NAT Entry
and
Step 2
to add up to 32 static NAT entries.
, highlight the entry in field
PPP over ATM LAN Configuration
C
ONFIGURATION
"Saving the Configuration" on page 21
‹
of the
Static NAT Entry
.
Port Address
"NAT" on page 57
and
Protocol
for the
Private
.
then click
page.
Megabit Modem 500L Installation Manual
PRELIMINARY
shown above).
for more information
,
Proxy
and
Remote
Delete
.
to save the WAN and LAN
.
Advertisement
Table of Contents
Troubleshooting
