Table of Contents
Advertisement
Configuring PPP over ATM Sessions
Defining User Assignment Parameters
You can map your PC to only one of the three sessions at a time. If you want
to use a different session, select User Assignment on the PPP over ATM WAN
Configuration page and move the user assignment to another session.
Enter the IP address for the PC that is assigned to this session.
1
Do the following to define
‹
Enter the
Service Name
Œ
Enter the
User's IP Address
(If the PC is mapped to one of the other two sessions, you must remove it from that
session to map it to this session.)
Displays the
‹
‹
2
Click
to accept a user assignment you entered in
Add
Delete a user assignment as follows:
1
Highlight the user assignment listed in
highlight the user assignment, it automatically displays in the
fields.)
Address
2
After adding or deleting all user assignments, click
38
Users' Assignments:
you entered for the session shown in field
for the LAN-side user that you assign to this session.
Service Name
and
User's IP Address
for the configured session.
Step
1.
(see figure above) then click
Done
to return to the
Megabit Modem 500L Installation Manual
PRELIMINARY
‹
on
page
36.
Œ
Œ
. (When you
Delete
and
Service Name
User's IP
EasySession
page.
Advertisement
Table of Contents
Troubleshooting
