Defining Static Nat Entries - PairGain 500L User Manual

PRELIMINARY

Defining Static NAT Entries

Static NAT entries are required only for applications that use TCP/UDP connections initiated
from the remote end (WAN). Through the
remote user to a user on your LAN. You can enter a maximum of 32 static NAT entries.
1 Do the following to map static NAT entries:
‹
Enter the
Private IP Address
Proxy IP Address you will enter in field
is the logical port for the protocol (UDP or TCP) you select for this NAT entry
Port
Your system administrator will provide the protocol port number.
Œ
Enter the
Proxy IP Address
the service provider (see the
IP address).
NAT entry
Megabit Modem 500L Installation Manual
for a user on the LAN that is mapped to the
which is the IP address assigned to a particular session by

field on
is the logical port for the protocol (UDP or TCP) you select for this
Port
Your system administrator will provide the protocol port number.
.
‹
, you can map inbound traffic from a
Static NAT Table
Œ
of the Static NAT Entry
page 36 for where to find the proxy
Œ
Chapter 6: Configuring Sessions
shown below.
.
 Ž

41