Saving The Configuration - PairGain 500L User Manual

PRELIMINARY
S
AVING THE
As you make changes to the modem configuration, click the
accept changes and write the changes to RAM. Some configuration changes are not permanent,
however, until you write them to Non-Volatile RAM (NVRAM) and reset the modem. You
must reset the modem to effect these changes:
• when defining PPP over ATM LAN settings (see
–
LAN IP address
– LAN network mask
•
when DHCP enabled (see
– DHCP start IP address
–
primary DNS IP address
– secondary DNS IP address
See the following sections to:
• save configuration changes to NVRAM
• reset the modem to activate the configuration
• reset the modem to restore the factory default values
Megabit Modem 500L Installation Manual
C
ONFIGURATION
page 39):
Chapter 4: Setting Up For Configuration
Submit
page 39):
(page 22)
(page 25)
(page 23)
button on the Web page to
21