PairGain 500L User Manual page 45

PRELIMINARY
Ž
Enter the
Chap Host
CHAP authentication of this session. The name must be identical for the user
session and for the service provider. See
from the service provider.

Select the
Enable
to translate the session IP address to private IP addresses. It is recommended that
you always enable NAT.
You can choose, however, not to use NAT for address translation. If you do not use
NAT, you can assign only one LAN user (one PC) to the session. The IP address for
the LAN user PC must be the same IP
the service provider (shown in field
PC to accept the entry of a manual IP address (select
manually enter the session IP address).

Select
Dynamic
assign an IP address for this session during set up. When the address is dynamically
assigned, the address field will display the assigned value after the session
comes up.
Select Fixed
for the session. If the address is fixed, type in the fixed IP addresses you recorded
on page 74
This IP address is also referred to as the proxy address for the session.
‘
Click User Assignment
session. Go to the section
configure the user assignments.
2 Click
Submit
3 To configure other sessions:
a Click
EasySession
configure. (Or, if you want to modify an existing session, click
locate the session you want to modify).
b Repeat Step 1
Deleting a PPP over ATM WAN Session Configuration
1 From the
PPP over ATM WAN Configuration
configuration you want to delete.
2 Click Delete
Megabit Modem 500L Installation Manual
name provided by the service provider. The name is used for
checkbox when you want to use NAT protocol (
as the
Address Assignment
as the Address Assignment
into the field "
If fixed, enter assigned IP address
to open a dialog in which you can map LAN users to each
"Defining User Assignment Parameters" on page 38
to accept the WAN PPP session configuration.
on the
Main Menu.
to configure the session.
to remove a configuration that is displayed on the current Web page.
page 73 for the CHAP name you recorded
Address Assignment

on page 36). See page 18
Specify an IP address
if the service provider will automatically
if the service provider gave you an IP address
."
then click by the
Edit
page, click
Previous
Chapter 6: Configuring Sessions
Address Translation
given to the session by
to configure the
then
to
that you want to
Port 1-3
or
Previous Next
or to access the session
Next
)
to
37