Bahco TAWM Series Original Instructions Manual page 7

TAWM SERIES
Note: If wrench is Locked (see Preset Lock in Advanced section), Clear Data function is disabled.
STD
SLIM
VIEWING AND CLEARING WRENCH CYCLE COUNTER
Each time torque or angle target is reached, wrench cycle counter is incremented. Maximum cycle
count is 999999.
1. From target torque or angle screen, press and hold ENTER button for 3 seconds.
2. Highlight CYCLE COUNT menu selection using UP/DOWN buttons.
3. Press ENTER button to display CYCLE COUNT screen.
4. To exit CYCLE COUNT screen without clearing count, press ENTER button while EXIT menu
selection is highlighted.
5. To reset wrench cycle count to 0, highlight CLEAR menu selection then press ENTER button.
6. EXIT menu selection is automatically highlighted after count is cleared. Press ENTER button to
return to main menu.
STD
SLIM
Note: If wrench is Locked (see Preset Lock in Advanced section) Clear count function is disabled.
LANGUAGE
1. To select the language menu, press the ENTER button while LANGUAGE is highlighted then
highlight the desired language and press the ENTER button.
2. Decimal Mark selection menu is displayed. Decimal separator can be a comma or decimal point.
Use UP/DOWN buttons to select the decimal separator then press the ENTER button.
Note: The decimal separator will affect the formatting of the downloaded data when opened by
Excel depending on Windows regional settings.
®
STD
SLIM
3. To exit Main menu and return to target torque or angle screen, press ENTER button while EXIT
menu selection is highlighted.
TARGET PRESETS (PSET)
PSET function gives user ability to configure 50 preset target torque or target angle settings, each with
a target, minimum, maximum (over range) and batch count value. PSETs are stored in non-volatile
memory so that they are retained while power is off.
Note: After adding a Preset (see below), navigate between manual target torque, angle mode
and PSET screen by repeatedly pressing ENTER button. While PSET screen is displayed, press
UP/DOWN buttons to select additional configured PSETs.
13