Renault MASTER User Manual page 172

TyrE PrEssUrE loss warning
2
resetting procedure
With the ignition on:
– repeatedly press button 3 or 4 to
select the "Tyre pressure init. long
press" function on the display 2;
– press and hold (around 3 seconds)
button 3 or 4 to start initialisation.
Display of the message "Learning
Tyre Pressures" indicates that the
reset request for the tyre pressure
reference value has been taken into
account.
Reinitialisation is carried out after a few
minutes' driving.
2.30
(2/3)
note:
The standard tyre pressure cannot be
less than that recommended and indi-
cated on the door frame.
3
Display
Display 2 on the instrument panel in-
forms you of any tyre pressure faults
4
(flat tyre, punctured tyre, etc.).
"adjust Tyre Pressure"
Warning light
along with the message "Adjust Tyre
Pressure".
These indicate that at least one tyre is
flat.
Check and, if necessary, readjust the
pressures of the four wheels when cold.
The warning light
few minutes' driving.
The sudden loss of pressure in a
tyre (burst tyre, etc.) cannot be de-
tected by the system.

comes on,

goes off after a
"check Tyre Pressure sensors"

The warning light
steady, accompanied by the message
"Check Tyre Pressure Sensors" and a
beep.
This message appears along with the
®
warning light.
They indicate that at least one wheel
is punctured or severely underinflated.
Replace it or contact an approved
dealer if it is punctured. Top up the tyre
pressure if the wheel is deflated.
®
Warning light
quires you to stop immedi-
ately, for your own safety,
as soon as traffic conditions
allow.
comes on
re-