Connector Interfaces; Connector Pinout - Axis 291 1U Installation Manual

AXIS Video Server Rack Installation Guide

Connector interfaces

The interfaces available via the 12-pin I/O terminal connector are as follows:
4 Digital inputs - used for e.g. a pushbutton. If the button is pressed, the state changes
•
and the input will be active (shown under Event Configuration > Port Status). (AXIS
241Q Blade, AXIS 241S Blade, AXIS 243Q, AXIS 240Q)
4 Transistor outputs - for e.g. alarm devices that can be activated from Output buttons
•
on the Live View page, or as an action to an Event Type. The output will show as active
(in Event Configuration > Port Status) if the device is activated.
• 10 configurable I/O connectors (AXIS Q7406)
RS-485 interface, for e.g. Pan/Tilt/Zoom devices (see www.axis.com for drivers)
•
• Auxiliary power

Connector pinout

Pin AXIS Q7406
1 +12V out, 100mA
2 GND
3 Channel 1, Configurable I/O 1
4 Channel 2, Configurable I/O 1
5 Channel 3, Configurable I/O 1
6 Channel 4, Configurable I/O 1
7 Channel 5, Configurable I/O 1
8 Channel 6, Configurable I/O 2
9 Channel 1, Configurable I/O 2
10 Channel 2, Configurable I/O 2
11 Channel 1, RS485A
12 Channel 1, RS485B
To connect input/output devices to the I/O terminal connector:
1. Referring to the table above, loosen the corresponding screw on top of the pin on the green
connector block.
2. Push the cable into the connector block and secure it by fastening the screw.
3. Once all devices are connected, push the connector block into the terminal connector on the
rear panel of the AXIS Video Server Rack.
For compatible replacement connectors, contact http://www.phoenixcontact.com, quoting: MC1.5/
12-ST-3.81 (art no 1803675).
AXIS 243Q
+12V out, 100mA
GND
Channel 1, Input 1
Channel 2, Input 1
Channel 3, Input 1
Channel 4, Input 1
Channel 1, Input 1
Channel 2, Input 1
Channel 3, Input 1
Channel 4, Input 1
Channel 1, RS485A
Channel 1, RS485B
Page 9
AXIS 241Q Blade,
AXIS 241S Blade, AXIS 240Q
+12V out, 100mA
GND
Input1
Input 2
Input 3
Input 4
Output1
Output2
Output3
Output4
RS485A
RS485B