Setting The Humidifier - Weinmann BiLevel ST 22 Description Of Unit And Instructions For Use

3. To save the Soft start time, press the Menu key
time is saved and the Soft start window closes automatically. If a key is not pressed for
4 seconds, the displayed Soft start time will be saved. The settings are retained when the
unit is switched off.
Note
BiLevel ST 22 starts automatically in Soft start mode if this was activated when the unit
was last used. Soft start can be switched on and off at any time by briefly pressing the
Soft start key

4.4 Setting the humidifier

The VENTIclick humidifier is used to humidify and warm the air prepared by the
BiLevel ST 22. There are 6 heating level options. Proceed as follows:
Refer to the Operating Instructions for the VENTIclick.
Note
• BiLevel ST 22 starts automatically with VENTIclick active if this was activated when the
unit was last used. VENTIclick can be switched on and off at any time by briefly pressing
22
EN Operation
2. Switch BiLevel ST 22 on and press the Soft start key
Soft start time with the dial (rotate to the right = in-
crease the time; rotate to the left = reduce the time),
or press the Soft start key
sion to increase the Soft start time in 5-minute incre-
ments. If you press the key again after reaching the
maximum time, the unit starts again from the mini-
mum time of 5 minutes.
.
1. Close the hose system or put the mask on.
2. Switch BiLevel ST 22 on and press the humidifier key
the dial to change the heat output (levels 1-6) of the
humidifier, or press the
3. To save the heat output time, press the Menu key
or the dial. The humidifier level window closes auto-
matically. If a key is not pressed for 4 seconds, the
displayed heat output will likewise be saved. The set-
tings are retained when the unit is switched off.
until the Soft start window appears. Change the
or the dial. The displayed Soft start
until the Humidifier Stage window appears. Use
several times in succes-
key several times.