Replacement From Eh-Rmp - Hitachi EH-RMP2 Applications Manual

Chapter 1 Introduction
1.5

Replacement from EH-RMP

Cautions of replacement from EH-RMP are shown below.
No. Item
1 Configuration tool
2 Configuration cable
3 Link parameter of
CPU module
4 Terminator
5 Rotary switch
6 Side DIP switch
7
8 Start-up time
9 LED indications
No. Item
1 Configuration tool
2 Configuration cable
3 Link parameter of
CPU module
4 Terminator
5 Rotary switch
6 Side DIP switch
7
8 Start-up time
9 LED indications
Table 1.5-1 Cautions of replacement from EH-RMP (Standard mode)
EH-RMP
Sycon
D-sub 9 pin
serial connector
Sending data area
is WLx000 to WLx0FF
Build-in
-
Output hold selecting
Operating mode selecting
5 second
RDY, RUN, STATUS,
ERR, TOKEN
Table 1.5-2 Cautions of replacement from EH-RMP (Compatible mode)
EH-RMP
Sycon
D-sub 9 pin
serial connector
Sending data area
is WLx000 to WLx0FF
Build-in
-
Output hold selecting
Operating mode selecting
5 second
RDY, RUN, STATUS,
ERR, TOKEN
EH-RMP2
SYCON.net Configurations file is not compatible between
EH-RMP and EH-RMP2. Please reconfigure
with use of SYCON.net.
When reconfiguration, please set 2 byte
boundaries in Module Alignment. Refer to
section 4.4 for details.
Type-B USB cable Please prepare the type-B USB cable.
Type-B USB cable is same as cable of using
in EHV / EHV+ series.
Sending data area Please change parameter with use of the
is WLx000 to WLx1FF programming tool.
At the time of the standard mode use, it
becomes link parameter error setting other
than WLx000 to WLx1FF.
Not Build-in Please use a connector
which has a termination switch.
The input / output sizes Please set rotary switch to "0".
of PROFIBUS network
Please set same settings.
Please set to standard mode setting.
10 second Please change user program.
RDY, RUN, ERR, Please check each application manual.
STATUS, REM
EH-RMP2
SYCON.net Configurations file is not compatible between
EH-RMP and EH-RMP2. Please reconfigure
with use of SYCON.net.
When reconfiguration, please set 2 byte
boundaries in Module Alignment. Refer to
section 4.4 for details.
Type-B USB cable Please prepare the type-B USB cable.
Type-B USB cable is same as cable of using
in EHV / EHV+ series.
Sending data area It isn't necessary to be change.
is WLx000 to WLx0FF At the time of compatible mode use, it
becomes link parameter error setting address
over WLx000 to WLx0FF.
Not Build-in Please use a connector
which has a termination switch.
The input / output sizes Please set rotary switch to "0".
of PROFIBUS network
Please set same settings.
Please set to compatible mode setting.
10 second Please change user program.
RDY, RUN, ERR, Please check each application manual.
STATUS, REM
1 – 4
Action
Action