Hitachi EH-RMP2 Applications Manual page 34

Chapter 4 Operation
(3) Double-click the "EH-IOCP2" in the main screen. Configuration dialog appears, click the "Modules". Next,
select the modules that are mounted in EH-IOCP2 base from the "Available Modules", and then click the "Insert"
button, please add to the "Configured Modules". Click the "OK" button at the end. It is possible to select the 22
modules maximum, select the "Empty slot" in empty slot part.
(The figure below shows an example that slot 0 is 16 points input, slot 1 is 16 points output.)
①Click
(4) Set up as shown in Figure 4.1.3-1. After turning on the power of EH-RMP2, connect the USB cable to config
port. (If a power supply is turned ON, with a USB cable connected, it will be detected as a device unknown at
Windows.)
(5) Double-click the "netX" in the main screen and click the "Driver".
Check the "netX Driver" and click the "OK" button.
①Click
②Select
④Addition
②Check
4 – 10
③Click
⑤Click
③Click