Table 5-14 Com0 Console Redirection Settings - Emerson NITX-300-ET-DVI Installation And Use Manual

Table 5-14 COM0 Console Redirection Settings

Field
COM0 (PCI Bus2,Dev10,Func1)
Console Redirection Settings
Terminal Type
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
Recorder Mode
Resolution 100x31
Legacy OS Redirection
NITX-300-ET-DVI Installation and Use (6806800N97A)
Description
Emulation: ANSI: Extended ASCII char set. VT100: ASCII char set.
VT100+: Extends VT100 to support color, function keys, etc. VT-
UTF8: Uses UTF8 encoding to map Unicode chars onto 1 or more
bytes. Items: VT100, VT100+, VT-UTF8, ANSI. Default is VT100.
Selects serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower
speeds. Items: 9600, 19200, 57600, 115200. Default is 115200.
Selects the data bits. Items: 7, 8. Default is 8.
A parity bit can be sent with the data bits to detect some
transmission errors. Even: parity bit is 0 if the num of 1's in the data
bits is even. Odd: parity bit is 0 if num of 1's in the data bits is odd.
Mark: parity bit is always 1. Space: Parity bit is always 0. Mark and
Space Parity do not allow for error detection. They can be used as
an additional data bit. Items: None, Even, Odd, Mark, Space.
Default is None.
Stop bits indicate the end of a serial data packet. (A start bit
indicates the beginning). The standard setting is 1 stop bit.
Communication with slow devices may require more than 1 stop
bit. Items: 1, 2. Default is 1.
Flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a 'stop' signal can be
sent to stop the data flow. Once the buffers are empty, a 'start'
signal can be sent to re-start the flow. Hardware flow control uses
two wires to send start/stop signals. Software flow control uses
start/stop ASCII chars, which slows down the data flow and can be
problematic if binary data is being sent. Items: None, Hardware
RTS/CTS. Default is None.
On this mode enabled only text will be send. This is to capture
Terminal data. Items: Disabled, Enabled. Default is Disabled.
Enables or disables extended terminal resolution. Items: Disabled,
Enabled. Default is Enabled.
On Legacy OS, the Number of Rows and Columns supported
redirection. Items: 80x24, 80x25. Default is 80x24.
BIOS
69