Ingeteam
3. The serial number of the communications card is displayed in the left section. Select the
serial number to find out the IP address obtained.
Once the IP address is known, add INGECON SUN 1Play to the plant using EMS Tools.
1. Control bar > Add device
2. From the pop-up window in Device Type select the type: PV Inverter.
·
·
·
·
·
·
3. Click on Find . If the unit is correctly connected and configured a warning is displayed
with the device's serial number and firmware.
4. Finally, save the settings by clicking on Save .
AAX2026IQM25_B.docx
Installation and configuration of a photovoltaic self consumption system with batteries
Select the connection type: Ethernet.
IP: IP address acquired by the inverter
Port: 502
Modbus node: 03
Alias: IS 1Play
Phase: R
51