Installation Design And Start-Up; Electrical Wiring Design Of The Installation - Ingeteam INGECON SUN EMS Board Installation And Configuration Manual

Ingeteam

3 Installation design and start-up

This section describes the necessary steps to design and start up the installation. Proceed as
follows:

1. Electrical wiring design of the installation.

2. Associated communications network design.
3. Electrical connection of the INGECON SUN STORAGE 1Play.
4. Communications network wiring connection.
5. System device configuration.
6. System device firmware update.
7. Configuration of the installation via the INGECON SUN EMS Tools software.
8. Connection and configuration of additional external photovoltaic units (optional).
3.1 Electrical wiring design of the installation
The design of the installation must be carried out according to the electrical
scheme defined by Ingeteam. The wiring diagrams can be found in the following
link:
Installation components:
·
Photovoltaic panels.
·
Battery bank.
·
INGECON SUN STORAGE 1Play + INGECON SUN EMS Board.
·
External wattmeter.
·
INGECON SUN 1Play (optional). To increase the photovoltaic power of the installation.
·
Contactor for connection of neutral to ground for TT installations. In the event of a power
cut, the ISS 1Play disconnects from the grid and activates this contactor to reference
the neutral of the critical loads to ground. In case of TN installations, this contactor is
not necessary.
AAX2026IQM25_B.docx
Installation and configuration of a photovoltaic self consumption system with batteries
http://www.ingeconsuntraining.info/?page_id=10550
31