Ingeteam INGECON SUN EMS Board Installation And Configuration Manual page 46

Installation and configuration of a photovoltaic self consumption system with batteries
1. Click on the Grid icon and check that the Power Meter Id parameter corresponds to the
external wattmeter previously configured.
7. Setting the SOC Levels
1. Click on the EMS icon
2. Configure the SOC values needed by the Strategy
Parámetro
SOC/VBat Maximum
SOC/VBat Minimum
SOC Recovery (%)
8. Re-starting the strategy
After adding and configuring all the devices in the installation, start up the strategy or system
control.
To do so:
After a few seconds, our system starts to operate.
46
Maximum SOC for charging the batteries (%). Set the same value as the
INGECON SUN STORAGE 1Play as SOC MAX.
SOC minimum: Minimum SOC for discharging the batteries (%). Set the
same value as the INGECON SUN STORAGE 1Play as SOC MIN.
SOC value in which the battery discharge will be re-established once the
SOC minimum has been reached
Control Bar > Control > Start control.
Descripción
AAX2026IQM25_B.docx
Ingeteam