Omnik NS Series User Manual page 7

The SN code, inverter model, firmware version, and hardware version of this inverter
can be seen in the "Info".
Up to 20 recent faults can be seen in the "Error", including fault code, time of fault
occurrence, and detailed fault description.
"Set" is used to set inverter time, language, password, security, protection etc.
End-users can set Date Time, Language by themselves. There is an installer
password required to operate on other advance settings, e.g. safety, password,
protection etc.
Note: Please contact with your installer or Omnik service team for the
installer password. The default factory default password is 500005.
Protection
Password input interface is as Fig. 5. Use the "Up" or "Down" button to select the
number. After setting the first digit, press the "ENTER" button to set the next number.
If the password was entered correctly, you can enter the setting interface, otherwise
re-enter.
User can set safety regulation according to different countries and grid-tied
standards.
Country
Select
As in Fig. 6, XXX is the current country regulation selection candidate. Press the "Up"
and "Down" keys to select the local security country and press "Enter" to confirm it.
XXXXXX
Fig. 5 Inputting password
Fig. 6 Safety regulation selection
XXX
Germany
France
Italy